Sewing
10 - 5
10
.03 Programmed sewing
With the program numbers 3 ā 49 it is possible to call up previously programmed seams. In
programmed sewing all seam sections for setting a sleeve are set in one seam program. The
information about the seam program, such as program number, number of programmed
seam sections, programmed comments and garment size is displayed.
For better orientation a seam sketch is shown as an armhole with the programmed seam
sections. The seam start, seam end, the seam sections already sewn, the current seam
section and the seam sections still to be sewn are illustrated by symbols and different types
of lines with different thicknesses. The parameters corresponding to the current seam
section, seam section number, top feed stroke (roller presser) with fullness adjustment,
bottom feed stroke (feed wheel), length of the seam section and thread tension, are
displayed. The top feed stroke (roller presser), fullness adjustment and thread tension can be
altered directly.
ā Switch on the machine and select the desired program number from "3" to "49", see
Chapter 9.07 Selecting the program number.
Explanation of the displays and functions
Program selection
This opens the menu for entering the program number, see Chapter 9.07 Selecting the pro-
gram number.
Seam section right/left
Shows the number of seam sections in the seam program for the right/left sleeve seam.
Input mode
Exit the sewing mode and select the input mode.
Current seam section
Shows the current seam section.
Automatic seam change
When this function is activated, the machine changes automatically from the right to left
sleeve seam.
Current seam
This function is used to select and display the current sleeve seam (right/left).
50
2.6
To Next Page
Loading...
Need help?
General
