Preparation
9 - 11
● Select parameter "104".
1
104
● Select parameter "105".
5000
105
● Enter the number of stitches, which are to be sewn with one bobbin.
● Conclude the input.
When the number of stitches entered have been sewn, the diode on the sewing head
panel flashes. After thread trimming the message "WARNING 2" appears on the display,
also see Chapter 13.08 Warning messages.
● Switch on the bobbin thread control with the reverse stitch count function (value "1").
● After changing the bobbin, acknowledge the elimination of the error.
WARNING 2
To Next Page
Loading...
