Pfaff creative 3.0

1:11
Introduction
Presser feet
0A - Standard presser foot for IDT
™
V\VWHP
DWWDFKHGRQWKHPDFKLQHXSRQGHOLYHU\
This foot is used mainly for straight stitching and zigzag stitching with a stitch length
longer than 1.0mm.
1A - )DQF\VWLWFKIRRWIRUIDT
™
V\VWHP
This foot is used for decorative stitches. The groove on the underside of the foot is
GHVLJQHGWRÁRZVPRRWKO\RYHUWKHVWLWFKHV
2A - )DQF\VWLWFKIRRW
When sewing decorative stitches or short zigzag stitches and other utility stitches with less
than 1.0mm stitch length, use this foot. The groove on the underside of the foot is designed
WRÁRZVPRRWKO\RYHUWKHVWLWFKHV
3 - Blindhem foot for IDT
™
V\VWHP
This foot is used for blindhem stitches. The toe on the foot guides the fabric. The red guide
on the foot is designed to ride along the fold of the hem edge.
4 - Zipper foot for IDT
™
V\VWHP
This foot can be snapped on either the right or the left of the needle, making it easy to sew
close to both sides of the zipper teeth. Move needle position to right or left to sew closer to
zipper teeth.
5A - Sensormatic buttonhole foot
When connected to the machine, the buttonhole is sewn in the length that has been entered
into the machine.
5M - Manual buttonhole foot
This foot is used for sewing manual buttonholes. Use the markings on the foot to position
WKHJDUPHQWHGJH7KHÀQJHURQWKHEDFNRIWKHIRRWKROGVFRUGLQJIRUFRUGHGEXWWRQKROH
6A - (PEURLGHU\Sensormatic free-motion foot
This foot is used for embroidery and free-motion sewing. This foot can also be used for
darning.
Important: Make sure that the IDT
™
system is disengaged when using presser foot 2A, 5A, 5M, and 6A.