5:3
Sequencing
Open and exit sequencing
Sequencing can only be used in sewing mode. To
open, touch the sequencing icon on the option
bar. To close sequencing and sew your created
sequence, touch OK in the top right corner in
sequenceing window.
Note: You can also close sequencing by pressing the
foot control or by pressing the start/stop button.
Not all stitches are available to use in a sequence.
If you try to select an unavailable stitch, a pop-up
will notify you.
Create a sequence
7RVWDUWFUHDWLQJDVHTXHQFHÀQGWKHGHVLUHG
stitch and/or font by opening the selection menu.
Create sequence from stitches
Open selection menu. Use the scroll arrows to
scroll through the list of stitches. Touch a stitch
in the selection area to add it to the sequence. To
get an overview of all stitch categories, touch the
stitch category icon.
Create sequence from letters
Open the selection menu. Touch stitch fonts to
open a window with available stitch fonts. Touch
to load the desired stitch font into sequecing.
Touch font style icon to toggle between upper or
lower case letters, numbers or special symbols.
Move the cursor through the sequence using the
forward/backward arrows. To delete a letter
or stitch, touch delete. Long touch to delete the
whole sequence.
The active position is marked by a cursor and the
selected stitch or letter will be marked in green.
Inserted stitches will be placed at the cursor
position. Only the selected stitch can be adjusted.
Stitch category
Scroll arrows
Font style
Forward/backward arrow
Delete
Stitches
Stitch fonts
Sequencing
Selection menu
To Next Page
Loading...
Need help?
General
