3:6
Machine settings & buttons
Buttons and indicators
Presser foot up and extra lift toggle
Touch this button to raise the presser foot. Touch
this button to raise the presser foot. Press the button
once more and the presser foot will raise to extra lift
position and the needle will raise to up position.
Presser foot down and pivot toggle
Touch this button to lower the presser foot
completely. Press the button once more to raise
the presser foot to pivot height. The presser foot is
lowered automatically when you start to sew.
Stitch restart
When you have stopped sewing in the middle of a
stitch, press stitch restart to return to the beginning
of the stitch again without having to reset any
special settings you have made.
If pressing the stitch restart button while sewing,
WKHVWLWFKZLOOEHÀQLVKHGDQGWKHPDFKLQHZLOOWKHQ
stop. You can also use stitch restart to go back to the
beginning of an embroidery.
Speed control
This function enables you to easily reduce the
sewing speed. Just touch the speed control button
to reduce the speed. To return to normal speed,
deselect the button.
Reverse button
Reverse indicator
Action indicator
Start/stop
Presser foot up and extra lift toggle
Thread snips
Presser foot down and pivot toggle
Stitch restart
Immediate tie-off
Needle up/down
Speed control
You can change the speed limit on your machine.
Long touch the speed control button to open a
pop-up. Set desired speed limit using the slider,
then close the pop-up. The next time you touch the
speed control button, the speed will be reduced to
the limit you have chosen. The limit will be shown
at the top left corner, either in sewing mode or
embroidery mode. You can sew without closing the
pop-up.
Immediate tie-off
Press immediate tie-off while sewing and your
machine sews a few tie-off stitches and stops
automatically.
By touching the tie-off button once more while the
action indicator is lit, the function can be turned off.
The tie-off function can be programmed, see page 4:10.
1HHGOHXSGRZQ
Press this button to move the needle up or down.
The setting of the needle stop position is changed
at the same time. When needle down is activated,
the indicator underneath the button is lit, the needle
will stop in the down position and the presser foot
will raise to pivot height.
You can also tap the foot control to raise or lower
the needle.
To Next Page
Loading...
Need help?
General
