3:4
Machine settings & buttons
Sewing settings
Twin needle
Touch the twin needle icon to open a list for twin
needle width selections. When a twin needle size is
selected, the width of all stitches is limited for that
needle size to prevent needle breakage. The setting
is kept until you deselect the twin needle width.
The stitch width of the selected stitch will
DXWRPDWLFDOO\EHDGMXVWHGWRÀWWKHWZLQQHHGOH
If you select a stitch that is too wide for the twin
needle size, a waring pop-up will appear. Select
"off" in the twin needle list to deselect twin needle
and go back to normal sewing.
6WLWFKZLGWKVDIHW\
Select this function when using the straight stitch
needle plate or a straight stitch presser foot to lock
the needle in center position for all stitches. Stitch
width safety will prevent damage to the needle
and/or presser foot.
When turning on the machine with this setting
activated and for every stitch selection that is not
a straight stitch, a pop-up informs you that it is set
to straight stitch. Deselect stitch width safety to go
back to normal sewing.
Note: Twin needle and stitch width safety cannot be used
at the same time.
Presser foot pressure
In some cases, you might need to adjust the presser
foot pressure. Specialty techniques or thick fabric
may require an adjustment. The higher the number
the more pressure on the fabric.
Automatic presser foot lift
When selected, the automatic presser foot lift is
activated. The presser foot will raise to pivot height
for example when stopping with the needle in the
down position. When deselected, the presser foot
will stay lowered even if the machine stops with the
needle in down position.
Thread snips for sewing
When selected, the automatic thread snips are
activated. The threads are cut automatically and the
presser foot raises when sewing is complete, e.g. a
buttonhole. When deselected, no automatic thread
snip will be performed.
Stitch width safety symbol
Twin needle symbol
List of twin needle width
Presser foot
pressure control
To Next Page
Loading...
Need help?
General
