5:4
Mirror
side to side
Mirror
end to end
Delete
Sequencing
Insert a stitch or letter
Move the cursor where you want to add a stitch or
letter. Select the desired stitch you want to insert. It
will be placed at the cursor position.
$GMXVWWH[WDQGstitches
You can mirror, adjust length and width or change
the density or position of the selected stitch. Some
stitches can be changed between two stitch settings
(width/positioning) and/or (length/density). This
will be indicated by a button symbol in the middle
of the stitch control. Toggle between the different
stitch settings by touching the button symbol in the
middle of the control. The adjustments work just
like in sewing mode.
Delete a stitch or letter
If you want to delete a stitch, move the cursor to the
stitch you want to delete and touch the delete icon.
Use the long touch function to delete the whole
sequence.
Replace a stitch or letter
To replace a stitch, simply select it and then touch
delete and insert the new stitch. It will be placed at
the cursor position.
Sequence commands
You can insert tie-off, stop and thread snip
commands into the sequence. These commands
will be included in the sequence and will always be
performed when sewing it.
Move the cursor to the position where you want to
add a command. Select it and an icon will be added
LQWRWKHVHTXHQFH7KLVFRQÀUPVWKDWWKHFRPPDQG
is inserted and it also shows where the command
will be performed in the sequence.
Use the tie-off command if you want a secure tie-off.
You can insert the tie-off commands anywhere in
the sequence.
Insert the thread snip command if you want the
machine to tie-off and cut the threads and raise the
presser foot.
Insert a stop command if you want the machine to
stop. This is useful for example at the end of the
sequence if you want to sew it only once or to create
a sequence in several rows.
Stop command
Tie-off command
Thread snip command
Stop command
Tie-off command
Thread snip command
Stitch width/
Stitch positioning
Stitch length/
Stitch density
Move cursor
Move
cursor
To Next Page
Loading...
Need help?
General
