4:11
Sewing mode
Sewing programs
These options let you activate tapering, single stitch
and patchwork programs. You can sew without
closing this pop-up.
Note: Not all programs can be used at the same time.
Tapering program
Tapering increases or decreases the width of the
stitch during sewing to create symmetrical or
asymmetrical tapers.
Activate tapering by selecting either of the tapering
icons. The default angle is 45 degrees. Long touch
a tapering icon to view the angle choices for that
taper. Select one angle for the beginning taper and
the same angle or a different one for the end taper.
If tapering is deactivated and then activated again,
the angle will be set to the previously selected angle.
When tapering is activated at both the beginning
and at the end and you start to sew, the stitch
width will start at 0mm. It becomes wider until the
selected stitch width is reached. Sew your desired
length and press the reverse button. The width
is reduced until the width is 0mm and the action
indicator on the machine will be lit until the taper is
ÀQLVKHG
Single stitch program
Activate the single stitch program by touching the
icon. The single stitch program lets you decide how
many repetitions of the stitch you want to sew.
Set the number of repetitions using the icons on the
right. The number of repetitions chosen is shown
between the + and - icons. The machine will stop
automatically when the repetitions are sewn.
Tapering program
Single stitch program
Patchwork program
Set number of stitch repetitions
in single stitch program
Sewing
programs
Pop-up for tapering program
Number of
repetitions
Single stitch
program
To Next Page
Loading...
Need help?
General
