9:9
Embroidery mode - stitch-out
Common (PEURLGHU\
stitch-out pop-ups
(PEURLGHU\XQLWFDOLEUDWLRQ
When the embroidery unit is attached, a pop-up
asks you to slide off the hoop and clear the machine
area for calibrating the embroidery arm. You will
also be reminded to disengage the IDT
™
system and
attach the correct embroidery presser foot.
Note: It is very important to remove the hoop, otherwise
the hoop or the embroidery unit may be damaged while
calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does
not match the size displayed on screen, the machine
cannot embroider. You must change the hoop to the
hoop size displayed in the pop-up or change the
hoop setting.
To change hoop settings, return to Embroidery edit
and touch select hoop icon.
Bobbin thread low - move to bobbin position?
When the bobbin thread is running low, a pop-up
message appears giving you an indication that the
bobbin needs to be changed soon. This gives you
an opportunity to plan where to stop embroidering
and change the bobbin.
It is possible to embroider until the thread has
completely run out. Press the start/stop button to
continue embroidering without closing the bobbin
thread low pop-up.
Touch cancel to remain at the current stitch position.
Touch OK to move the hoop to bobbin position. The
hoop position tab opens. Replace the empty bobbin
with a full one. Touch Current position and pull
back excess needle thread. Press start/stop or press
your foot control to continue embroidering.
To Next Page
Loading...
Need help?
General
