Sewing
26
8.03.01 Description of the error messages
Error-
code
Cause Remedy
Err: 1 Pedal not in rest position Check pedal
Err: 9 Start inhibitor at standstill Bring sewing head to its basic positi-
on (Check parameter "665")
Err: 10 Machine class altered Switch control unit off, then on again.
Err: 14 Bobbin cover open Close bobbin cover
Err: 62 Voltage of power supply unit (24 V)
too low
Check connected consumers
Err: 63 Power supply unit (24 V) overloa-
ded
Check connected consumers
Err: 64 "Mains off" signal when machine is
switched on
Contact service
Err: 65 IGBT error when machine is swit-
ched on
Contact service
Err: 66 IGBT test with error recognition Contact service
Err: 68 Overcurrent motor during opera-
tion
Contact service
Err: 70 Motor blocking Check machine for binding
8.03 Error messages
When an error occurs, the text "Err:" appears on the display together with an error code, as
shown in the example below. An error message can be caused by incorrect settings, defec-
tive elements or overload conditions.
● Eliminate error.
● If necessary, acknowledge error elimination.
Err: 1
To Next Page
Loading...
Need help?
General