Control elements
15
6.02.02 Function keys
The function keys 3 described below generally have two basic functions:
● To switch the sewing function on or off (LED in the "TE/Input" key is off)
An activated function is always shown by the corresponding illuminated LED.
● To alter the set values shown on the display (LED in the "TE/Input" key is on)
Press and hold the appropriate function key to slowly change the set value shown above
it. If the function key is pressed longer, the set value changes more quickly.
Description of the individual functions:
Start bartack / A+
● If the "TE / Input" key is switched off, the bartacks at the beginning of the seam (start
bartacks) are switched on or off, see Chapter 9.01.03 Entering bartack stitches.
● If the "TE / Input key" is switched on, this function key serves as a plus function for the
setting range (A).
End bartack / A-
● If the "TE / Input" key is switched off, the bartacks at the end of the seam (end bartacks)
are switched on or off, see Chapter 9.01.03 Entering bartack stitches.
● If the "TE / Input key" is switched on, this function key serves as a minus function for the
setting range (A).
Raised needle position after sewing stop / B+
● If the "TE / Input" key is switched off, the "raised needle position after sewing stop" func-
tion is switched on or off. If the function is switched on, the needle positions in t.d.c.
take-up lever after sewing stops
● If the "TE / Input key" is switched on, this function key serves as a plus function for the
setting range (B).
Thread trimming / B-
● If the "TE / Input key" is switched off, the thread trimmer is switched on or off.
● If the "TE / Input key" is switched on, this function key serves as a minus function for the
setting range (B).
Raised foot position after sewing stop / C+
● If the "TE / Input key" is switched off, the "raised foot position after sewing stop" function
is switched on or off. If the function is switched on, the sewing foot is raised after sew-
ing stops.
● If the "TE / Input key" is switched on, this function key serves as a plus function for the
setting range (C).
Raised foot position at end of seam sector / C-
● If the "TE / Input key" is switched off, the "raised foot position at end of seam sector"
function is switched on or off. If the function is switched on, the sewing foot is raised at
the end of the seam sector.
● If the "TE / Input key" is switched on, this function key serves as a minus function for the
setting range (C).
To Next Page
Loading...
Need help?
General