Service functions
65
10.01.03 Deleting all seam programs
With this function all seam program inputs are deleted.
● Call up the reset function, see Chapter 10.01.01 Calling up the reset function.
Danger of unintentional data loss!
After operating the corresponding function key, the selected reset is carried
out without further check.
● Delete the seam program inputs by pressing the corresponding function key.
The seam program inputs are deleted. The following display appears on the screen for a
short time.
After the operation is completed, the previous machine status is called up again
automatically.
SewReset
1 2 3
To Next Page