Sewing
27
Error-
code
Cause Remedy
Err: 71 Incremental transmitter of motor
not connected
Check plug of incremental transmitter
Err: 73 Faulty running of motor (set rotati-
on speed not reached)
Check machine for binding
Err: 74 No synchronisation impulse from
sewing head
Check transmitter
Err: 92 Start inhibitor running during drive Check end switch
Err: 173 Motor not connected Check motor connection
8.03.02 Error messages for sewing head recognition unit (only on EcoDrive P74 ED-L)
The sewing head recognition unit is an external component, in which the corresponding
parameters for the sewing machine are fi led. Following messages can appear on the display:
Error code Cause Remedy
No Ident No sewing head recognition
unit recognized when machine
switched on
Replace sewing head recogni-
tion unit
New Ident A new sewing head recognition
unit was installed
Select and confi rm machine
class (under Parameter 799)
ILLIdent Sewing head recognition unit
and software do not match
CRC bad Test sum of sewing head
recognition unit inaccurate
Replace sewing head recogni-
tion unit
BadIdent Sewing head recognition unit
defective
Replace sewing head recogni-
tion unit
No Ident
To Next Page
Loading...
Need help?
General