11 Upgrades
217
8
Fit the new connector cover that comes with the upgrade kit. First, locate the three lugs along the
top edge of the connector cover in the corresponding recesses in the bottom housing. Then push
the bottom of the cover so that the three latches snap securely into position.
9 Replace the front end assembly as described in “Replacing the Front End Assembly” on page 202.
10 Fit the noninvasive blood pressure assembly as described in “Replacing the Noninvasive Blood
Pressure Assembly” on page 192.
11 Replace the top cover assembly as described in “Replacing the Top Cover Assembly” on page 180.
12 For tests to perform after upgrading, see “When to Perform Tests” on page 56.
To Next Page
Loading...
