Using the System Registering Your Transducers
76 Lumify Ultrasound System
Philips Healthcare 4535 618 58571_A/795 * MAY 2016
NOTE
If you upgrade the Lumify app or the Android operating system, the system prompts you to
reregister the next time you connect a transducer.
Registering Your Transducers
1. Make sure that your device is connected to a wireless or cellular network.
2. Start the Lumify App.
3. Connect your Philips transducer to your device. The first time you connect the transducer
to your device, the device prompts you to Open Lumify When This USB Device is
Connected. Select Use By Default For This USB Device, and then touch OK. The Lumify app
performs a system check and registers your transducer.
4. On the Registration Complete display, touch Accept to begin using the system.
If registration fails, see “Troubleshooting” on page 153, or visit the Lumify portal for FAQs and
troubleshooting tips:
www.philips.com/lumify
Giving Lumify Access to Shared Device Storage
Lumify uses shared device storage for the patient database and to access your device's camera
for barcode scanning.
Some versions of the Android operating system require that you specify that an app is allowed
access to shared device storage. If your device prompts you to allow Lumify to access photos,
media, or files on your device, touch Allow. If you touch Deny, you cannot use Lumify until you
give access to shared device storage in the Android App Permissions settings.
To Next Page
Loading...