Other Functions You Can Configure
3-34 Setting up your Monitor
Setting up your
Monitor
4. Press to return to the Main Screen.
You can also switch OFF parameters in the following ways:
• Any parameter: unplug the module, and suspend or silence the
alarms.
• Any parameter except ECG, RESP or NBP: disconnect the
transducer or adapter cable from the module, and suspend or
silence the alarms.
If you switch off a parameter, you can ONLY enter the parameter's Setup
Task Window (via the module's hardkey) by first pressing
→ .
When you plug in a parameter module and connect the transducer or
adapter cable, the parameter is automatically switched on. (ECG, RESP
and NBP are automatically switched on when you plug in the relevant
module.)
Main Screen
Module Setup
To Next Page
Loading...
