Loading Paper
Recording Functions 6-55
Note—The first sheet will come out folded, as shown.
Cleaning the
Roller on
the Four
Channel
(M1117A)
Recorder
If the paper doesn’t move through the roller properly, a possible cause is
that the roller needs to be cleaned. (Be sure your hands are clean before
touching the roller).
Equipment
Required
• Lint-free cloths or wipes
• Alcohol solvent that is low in water content. We recommend either
reagent grade denaturated ethanol or isopropanol (90% rather than
70%)
Directions 1. Turn the power off.
2. Open the door and remove any paper from the recorder.
3. Wipe the visible part of the roller with a saturated (but not dripping)
cloth. Rotate the roller with clean fingertips to expose the entire
surface and wipe the other side.
4. Remove any excess liquid by wiping with a dry cloth.
Caution
The roller must be completely dry before using the recorder or you can
permanently damage the recording mechanism.
Step 3 Close the door. The paper should feed
automatically.
To Next Page
Loading...
