Introduction
1-12 The CMS and V24 and V26 Patient Monitors
The CMS and V24 and
V26 Patient Monitors
Hardkey
Functions
- press to silence an alarm or alarms that are sounding
or, if alarms are latching, to reset them.
- press to suspend or switch on all alarms. The current state
is indicated by the Alarm Suspend Lamp.
- press to return to the main monitoring screen.
- (CMS only) press to change between screen layouts
or to access a 2nd or 3rd display. You can also freeze any wave
movement on the screen (INOPs, alarms and numerics are not affected).
- press to record pre-selected waves onto a system
recorder or a bedside recorder.
- press to record pre-selected waveforms that are no
longer on the monitor screen.
- press to enable you to suspend or switch on alarms, set and
review alarm limits, enter Monitor Standby, or set the alarm volume.
- press to enable you to view data from other beds in
your group.
- press to enable you to pre-select certain system
characteristics.
- press to enable you to set up and perform procedures
such as Cardiac Output, Wedge Pressure (CMS only), ST analysis, Drug
Calculations, admit and discharge patients, or end a particular patient
case and transfer patient data.
- press to enable you to view vital signs and graphical
trends, make and review calculations, print reports and mark events to
view in graphs.
- press to enable you to change or adjust parameter
settings, switch parameters on or off, or set up parameters.
Keys
Silence/Reset
Suspend
Main Screen
Change Screen
Realtime Record
Delayed Record
Alarms
Other Patients
Monitor Setup
Procedures
Trends/Calcs
Module Setup
Arrow
To Next Page
Loading...
