Setting up and connecting the printer
103933_en_01 PHOENIX CONTACT 2-11
• Once you have entered the IP address, click on "Start".
The printer driver is installed and the printer is then ready for operation.
The display language is set to English by default. You can switch to a different language
(see "Changing the language setting" on page 3-7).
Reading the IP Address
If your network has DHCP, the IP address can be called via the BLUEMARK LED display.
• Press the f key to access the menu.
The printer switches to offline mode, i.e., printing is no longer possible.
• Confirm the Settings item by pressing the
• key.
• Select Interfaces via d. Confirm by pressing the • key.
• Select LAN Parameter via d. Confirm by pressing the
• key.
• Select Info IP Config via d. Confirm by pressing the
• key.
IP Address Assignment
The Ethernet interface is in DHCP mode by default. This means that the IP address is
assigned automatically.
The menu can be used to set DHCP mode to "Not active" and to manually assign an
IP address.
Your system administrator should inform you of the IP address, subnet mask, and standard
gateway to be set.
Exiting DHCP mode • Press the f key to access the menu.
The printer switches to offline mode, i.e., printing is no longer possible.
• Confirm the Settings item by pressing the
• key.
• Select Interfaces via d. Confirm by pressing the
• key.
• Select LAN Parameter via d. Confirm by pressing the
• key.
• Select DHCP Mode via d. Confirm by pressing the • key.
• Select Not active via cd. Confirm by pressing the
• key.
Manually assigning an
IP address
• Go back one level by pressing the e key.
• Select TCP/IP IP Address via d. Confirm by pressing the
• key.
• Set the IP address using the arrow and cursor keys. Confirm by pressing the
• key.
This IP address must match the IP address specified at driver installation.
• Select TCP/IP Subnetmask via d. Confirm by pressing the
• key.
• Set the subnet mask using the arrow and cursor keys. Confirm by pressing the
• key.
• Select TCP/IP Standardgateway via d. Confirm by pressing the • key.
• Set the standard gateway using the arrow and cursor keys. Confirm by pressing the
• key.
• The f key can be used to return directly to the start screen (Ready).
To Next Page
Loading...
Need help?
General