BLUEMARK LED
3-2
PHOENIX CONTACT 103933_en_01
3.3 Starting printing
Figure 3-2 Do not access the device through the device openings
If nothing is printed for two minutes, the printer head temperature will be reduced in order to
save energy. After this, the printer will require a warm-up time of approximately one 1 minute
before it can begin processing a new print job.
3.3.1 Canceling an active print job
During printing, the following appears in the display:
Figure 3-3 "Print" display
• The active print job can be canceled by pressing the • key.
• "Cancel Print" then appears in the display.
Select "Back" to continue the print job and
"Continue" to cancel the print job.
WARNING: Danger of crushing
There are moving parts inside the printer. Never operate the BLUEMARK LED without its
cover in place and do not attempt to access the inside of the device through the device
openings during operation.
To Next Page
Loading...
Need help?
General