MATH OPERATION Commands
There are eight math operations. Only one of them can be enabled at a
time. They either store data for later use or perform mathematical
operations on the readings. Note that these eight math operations are
available to all measurement functions except continuity and diode
testing.
The math operations use one or more internal registers. You can preset
the values in some of the registers, while others hold the results of the
math operations.
CALCulate:
FUNCtion {PERCent|AVERage|NULL|LIMit|MXB|DB|DBM}
FUNCtion?
STATe {OFF|ON}
STATe?
CALCulate:
PERCent:TARGet {<value>|MINimum|MAXimum}
PERCent:TARGet? [MINimum|MAXimum]
CALCulate:
AVERage:MINimum?
AVERage:MAXimum?
AVERage:AVERage?
AVERage:COUNt?
CALCulate:
NULL:OFFSet {<value>|MINimum|MAXimum}
NULL:OFFSet? [MINimum|MAXimum]
CALCulate:
LIMit:LOWer {<value>|MINimum|MAXimum}
LIMit:LOWer? [MINimum|MAXimum]
LIMit:UPPer {<value>|MINimum|MAXimum}
LIMit:UPPer? [MINimum|MAXimum]
To Next Page
Loading...
