Remote Interface Operation
Use the following commands to enable and configure MX+B function:
CALCulate:FUNCtion MXB
CALCulate:STATe {OFF|ON}
CALCulate:STATe?
CALCulate:MXB:MMFactor {<value>|MINimum|MAXimum}
CALCulate:MXB:MMFactor? [MINimum|MAXimum]
CALCulate:MXB:MBFactor {<value>|MINimum|MAXimum}
CALCulate:MXB:MBFactor? [MINimum|MAXimum]
4.3.7 dB/dBm
A. dB
Definition
The dB feature takes a DC or AC voltage measurement and displays it in
decibel unit in correspondence to a relative reference value. The
calculation of dB is listed below:
or
dB = (Input signal in dBm) – (relative value in dBm)
※
NOTE: The
in
V
is the input signal and the
ref
V
is the relative reference.
The dB measurement is applied to DC and AC voltage only. The relative
value is adjustable and is stored in a volatile memory. The range for the
relative value is between 0
dBm and 200 dBm.
How to set the relative value
You can either manually select a number for the relative reference or let
the multimeter
take the first reading
(0 dB).
Front Panel Operation
Press CONFIG+ SHIFT+ NULL buttons, and then use
◁
and
▷
to move
through the digits and
△
and
▽
buttons to increase or decrease the
numbers to your desired value. Press ENTER to set the value. The
)log(20
Vref
V
dB
in
×=
To Next Page
Loading...
