On 6 ½ 6 ½
※
Note: To change resolution, refer to Section 4.1.3: Resolution Setting
in this chapter.
Figure 4-1
Remote Interface Operation
To set Auto Zero through the remote interface, use the following
commands:
SENSe:ZERO:AUTO {OFF|ONCE|ON}
The OFF and ONCE parameters have a similar effect. Auto Zero OFF
doesn’t issue a new offset measurement. However, Auto Zero ONCE
issues an immediate offset measurement.
4.1.2 Filter
Filter is used to remove noises in measurement readings. M3500A is
equipped with two types of filters: AC filter and digital filter. AC filter is
for AC measurements only. It also affects the speed of the multimeter
to yield a measurement reading. Digital filter further stabilizes the
measurement readings by averaging. Both of them are described in
To Next Page
Loading...
