Pioneer SC-LX904 - ZONE B Playback

126
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
ZONE B Playback
While performing playback through speakers (ZONE A) connected to the unit, you can enjoy the audio of the same source with the pre-main amplie, etc. (ZONE B) (
p87) connected to the ZONE B LINE OUT jack at the same time.
Playing Back
1. Press the button on the remote controller to select "Audio" - "Zone B".
• In the following cases, "Zone B" cannot be selected.
– When ZONE 2 is On
– When "System Setup" - "Speaker" - "Conguration" - "Zone 2 Preout" on
the Home screen is set to "Zone 2"( p159)
2. Select an audio output destination.
Off: Outputs audio only to ZONE A. "A" on the display of the main unit lights
up.
On(A+B): Outputs audio to both ZONE A and ZONE B. "A" and "B" on the
display of the main unit light up.
On(B): Outputs audio only to ZONE B. "B" on the display of the main unit
lights up.
3. Start play on the AV component.
4. Adjust the sound volume on the pre-main amplier, etc. of ZONE B.
• When "Zone 2 Preout" is set to "Zone B" and "Audio" - "Zone B" at AV Adjust is
set to "On (A+B)", the output of ZONE A is as shown below.
– The tone cannot be adjusted.
– "System Setup" - "Speaker" - "Crossover" - "Double Bass" (
p161) on
the Home screen is xed to "On".
– The effect of "System Setup" - "Speaker" - "Distance" ( p161) on the
Home screen turns off.
• If "On (A+B)" is selected as an audio output destination, you can select only
the "Stereo" listening mode for ZONE A when using the 2.1ch speaker layout.
When using a speaker layout of 3.1ch or more, you can select only the "Ext.
Stereo" listening mode.