EasyManuals Logo

Pioneer SC-LX904 User Manual

Pioneer SC-LX904
225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
125
Front Panel Rear Panel Remote
Contents
Connections
Playback
Setup
Playing Back (ZONE 3)
In the remote controller operation, while pressing and holding the ZONE 3 button
on the remote controller, operate with each button.
1. Point the remote controller at the unit, and while pressing and holding the
ZONE 3 button on the remote controller, press .
"Z3" on the display of the main unit lights up.
2. While pressing and holding the ZONE 3 button on the remote controller,
press the input selector of the input source you want to play in the separate
room. When operating on the main unit, press the ZONE CONTROL button
repeatedly to select "Z3" on the display, then within 8 seconds select the input
you want to play in another room using the input selector dial.
3. If the unit is connected to the pre-main amplier in the separate room, adjust
the volume on the pre-main amplier. If the unit is connected to the power
amplier or ZONE speaker in the separate room, adjust the volume with the
volume button while pressing and holding the ZONE 3 button on the remote
controller. When operating on the main unit, press the ZONE CONTROL
button repeatedly to select "Z3" on the display, then within 8 seconds adjust
using the MASTER VOLUME knob.
When connecting the power amplier, set "Multi Zone" - "Zone 3" - "Output
Level" ( p175) to "Variable" on the System Setup menu. If it is not set, a large
volume is output and the power amplier, speakers, etc. may be damaged.
If you turn the unit to standby during multi-zone playback, the Z3 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 3 to on while the unit is in standby also switches the
playback mode to playback in a separate room only.
For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
DSD audio signals cannot be output to ZONE 3 when selected with the "NET"
or "USB" input selector.
If ZONE 3 is on, power consumption during standby will increase.
To set the function to off: While pressing and holding ZONE 3 button, press
.
Alternatively, press the ZONE 3 ON/OFF button on the main unit.

Table of Contents

Other manuals for Pioneer SC-LX904

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pioneer SC-LX904 and is the answer not in the manual?

Pioneer SC-LX904 Specifications

General IconGeneral
BrandPioneer
ModelSC-LX904
CategoryReceiver
LanguageEnglish

Related product manuals