164
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
DTS/IMAX
Change the setting of when DTS signals are input.
Setting Item Default Value Setting Details
Dialog Control 0 dB You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
IMAX Mode Auto Set the IMAX sound mode.
"Auto": IMAX sound mode is automatically applied
when IMAX content is detected.
"On": In cases when this unit is unable to recognize
IMAX content, you can apply the IMAX sound
mode by turning this setting "On".
"Off": Disable this function
IMAX User
Setting
Auto When playing IMAX content with the IMAX sound
mode, select whether to automatically apply the
speaker setting recommended by IMAX or to set it
manually.
"Auto": To use the speaker setup recommended by
IMAX.
"Manual": To manually set "IMAX Bass Feeding"
and "IMAX LFE Mute Level".
• This cannot be selected when the IMAX Mode
is "Off".
IMAX Bass
Feeding
On
Set the route for the bass component of the audio.
"On": The bass component of each channel is output
according to the crossover settings ( p160)
"Off": Only the LFE signal is output.
• This cannot be selected when the "IMAX User
Setting" is "Auto".
IMAX LFE Mute
Level
0 dB You can set the volume for the LFE when IMAX
signals are being input. Select "–∞ dB" or a value
between "0 dB" and "-20 dB".
• This cannot be selected when the "IMAX User
Setting" is "Auto".
LFE Mute Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series,
Multichannel PCM, and DSD signals.
Setting Item Default Value Setting Details
LFE Mute Level 0 dB
Select the low-frequency effect (LFE) level of each
type of signal from "0dB" to "-∞dB". If the low-
frequency effect sound is too strong, select "
–
20dB"
or "
–
∞dB".
• This function is disabled when the IMAX sound
mode has been applied.
Volume
Change the Volume settings.
Setting Item Default Value Setting Details
Mute Level -∞ dB Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞ dB",
"-40 dB" and "-20 dB".
Volume Limit Off Set the maximum value to prevent the volume
from becoming too loud. Select a value from "Off",
"-32 dB" to "+17 dB".
Power On Level Last Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "-∞ dB", and "-81.5 dB" to
"+18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Headphone Level 0.0 dB Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".
To Next Page
Loading...
Need help?
General
