147
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
(*1) A center speaker or surround speakers need to be installed.
(*2) If the input source is Blu-ray Disc and the speaker layout is 5.1ch or less, DD+ cannot be selected. Instead, the listening mode for DD can be selected.
(*3) The listening mode displayed depends on the speaker layout ( p139, 140). Furthermore, when the setting for “Speaker Virtualizer” ( p163) is “Off” (default
value is On), then modes other than Atmos and Dsur cannot be selected.
(*4) Surround back speakers need to be installed. Can be selected when the input format is 5.1 ch.
(*5) If the input format is any of the following and the channel count is monaural, this listening mode becomes unavailable.
– DTS, DTS 96/24, DTS Express, DTS-HD HR, DTS-HD MSTR, PCM, music le
(*6) Cannot be selected when the IMAX Mode ( p164) is set to “Off” (the default value is Auto).
(*7) Cannot be selected when the input format is monaural.
(*8) Surround speakers or height speakers need to be installed.
(*9) A center speaker, surround speakers, or height speakers need to be installed.
(*
10
) Cannot be selected if "Speaker Virtualizer" ( p163) is set to "Off".
(*
11
) Surround speakers need to be installed.
(*
12
) You cannot select any mode other than Pure Direct, Stereo, Ext.Stereo and Ext.Mono if the sampling rate is 5.6/11.2 MHz.
(*
13
) This can only be selected when no surround back speaker is connected.
(*
14
) Can only be selected when the IMAX Mode ( p164) is set to “Off” (the default value is Auto).
Speaker Layouts and Selectable Listening
Modes ( p136)
To Next Page
Loading...
