To Next Page

To Previous Page

User’s Manual of GS-5220-16S8C & GS-5220-16S8CR

: Click to undo any changes made locally and revert to previously saved values.

: Click to refresh the Page. Note that non-committed changes will be lost.

4.12.2 Access Management

Configure access management table on this Page. The maximum entry number is 16. If the application's type match any one of

the access management entries, it will allow access to the switch. The Access Management Configuration screen in Figure

4-12-2 appears.

Figure 4-12-2: Access Management Configuration Overview Page Screenshot

The Page includes the following fields:

Object Description

 Mode

Indicates the access management mode operation. Possible modes are:

Enabled: Enable access management mode operation.

Disabled: Disable access management mode operation.

 Delete

Check to delete the entry. It will be deleted during the next apply .

 VLAN ID

Indicates the VLAN ID for the access management entry.

 Start IP address

Indicates the start IP address for the access management entry.

 End IP address

Indicates the end IP address for the access management entry.

 HTTP/HTTPS

Indicates the host can access the switch from HTTP/HTTPS interface that the

host IP address matched the entry.

 SNMP

Indicates the host can access the switch from SNMP interface that the host IP

address matched the entry.

 TELNET/SSH

Indicates the host can access the switch from TELNET/SSH interface that the

host IP address matched the entry.

272

Planet GS-5220-16S8C User Manual

Other manuals for Planet GS-5220-16S8C