EasyManuals Logo

Planet IGS-10020 Series Command Guide

Planet IGS-10020 Series
433 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
Command Guide
-156-
4.2.65.112 spanning-tree
Command:
spanning-tree
spanning-tree Spanning Tree protocol
Default:
Disabled
Usage Guide:
To enable STP for specific interface
Example:
To enable STP for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree
4.2.65.113 spanning-tree auto-edge
Command:
spanning-tree auto-edge
spanning-tree Spanning Tree protocol
auto-edge Auto detects edge status
Default:
Enabled
Usage Guide:
To enable Auto Edge of CIST Normal Port Configuration for specific interface
Example:
To enable Auto Edge of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree auto-edge

Table of Contents

Other manuals for Planet IGS-10020 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planet IGS-10020 Series and is the answer not in the manual?

Planet IGS-10020 Series Specifications

General IconGeneral
BrandPlanet
ModelIGS-10020 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals