Command Guide
-189-
4.2.69 ip arp inspection translate
Command:
ip arp inspection translate
ip Internet Protocol
arp Address Resolution Protocol
inspection ARP inspection
translate arp inspection translate all entries
Default:
N/A
Usage Guide:
To translate dynamic entries into static ARP inspection table.
Example:
To translate dynamic entries into static ARP inspection table.
Switch# configure terminal
Switch (config)# ip arp inspection translate
ARP Inspection:
Translate 1 dynamic entries into static entries.
4.2.70 ip arp inspection translate interface
Command:
ip arp inspection translate interface [10GigabitEthernet | GigabitEthernet] <vlan_id>
ip Internet Protocol
arp Address Resolution Protocol
inspection ARP inspection
translate arp inspection translate all entries
interface arp inspection entry interface config
GigabitEthernet 1 Gigabit Ethernet Port
10GigabitEthernet 10 Gigabit Ethernet Port
<vlan_id> Select a VLAN id to configure
<mac_ucast> Select a MAC address to configure
<ipv4_ucast> Select an IP Address to configure
Default:
N/A