Command Guide
-239-
Default:
5
Usage Guide:
To configure Transmission Time of Loop Protection
Example:
To configure Transmission Time (8) of Loop Protection
Switch# configure terminal
Switch (config)# loop-protect transmit-time 8
4.2.121 mac address-table aging-time
Command:
mac address-table aging-time <0,10-1000000>
mac MAC table entries/configuration
address-table MAC table entries/configuration
<0,10-1000000> Aging time in seconds, 0 disables aging
Default:
300
Usage Guide:
To configure Aging Time of MAC Address Table
Example:
To configure Aging Time (888) of MAC Address Table
Switch# configure terminal
Switch (config)# mac address-table aging-time 888
4.2.122 mac address-table static
Command:
mac address-table static <mac_addr> vlan <vlan_id> interface * | 10GigabitEthernet
<port_ty
pe_list>
| GigabitEthernet <port_ty
pe_list>
mac MAC table entries/configuration
address-table MAC table entries/configuration
static Static MAC address
To Next Page
Loading...
Need help?
General
