User Manual of WDRT-1800AX
-67-
If you can find a wireless network but can't connect, follow these steps:
1. Authentication problem/password mismatch
The default wireless password is usually on the label stuck on the back of the device. If the default password is
incorrect, please try to restore the factory settings and connect again
Note:Wireless passwords are case sensitive
2. Windows cannot connect to xxx/Cannot connect to this network/Connected to this network for too
long
1. Check the signal strength of the network. If it is weak, move the device closer to the router.
2. Change your router's wireless channel to 1, 6, or 11 to reduce interference from other networks.
3. Reinstall or update the wireless card driver
FAQ 6. How to switch the working mode of the router?
1.Visit http://192.168.1.1
2.Go to RouterEquipment mode
3.Choose the working mode you need
Note: In bridge and relay modes, some functions of the router cannot be used. To use the full functions, please use the
routing mode
FAQ 7. How to troubleshoot wireless relay failure
Fault 1: Unable to search for Wi-Fi that needs to be relayed.
Look for channels with low channel interference. Both the main route and the sub-route are fixed to this channel.
To Next Page
Loading...
Need help?
General
