Planmeca Viso - Selecting Patient Size for 2 D Exposure

E270 Timeout Timeout in lift motor which is
connected to PSU PCB J10.
Check the sensor, cable,
motor and the PSU PCB.
E275 Timeout in patient support motor
which is connected to CPU PCB J20
and controlled by MCM module 3.
Check the sensors, cables
and the motor.
E277 Timeout in collimator Y1 upper motor
which is connected to CAM PCB J23
and controlled by MCM module 5.
Check the sensors, cables
and the motor.
E278 Timeout in collimator X motor which
is connected to CAM PCB J24 and
controlled by MCM module 5.
Check the sensors, cables
and the motor.
E279 Timeout in collimator X1 right motor
which is connected to CAM PCB J24
and controlled by MCM module 5.
Check the sensors, cables
and the motor.
E280 Timeout in collimator Y motor which
is connected to CAM PCB J25 and
controlled by MCM module 5.
Check the sensors, cables
and the motor.
E281 Timeout in tube head rotation motor
which is connected to CAM PCB J22
and controlled by MCM module 6.
Check the sensors, cables
and the motor.
Error
code
Explanation Comments
E282 Timeout Timeout in collimator filter revolver
motor which is connected to CAM
PCB J22 and controlled by MCM
module 6.
Check the functionality of
the belt cables and the
motor.
E283 Timeout in collimator filter motor
which is connected to CAM PCB J20
and controlled by MCM module 7.
Check the adjustments and
the movement area.
E284 Timeout in collimator X2 left motor
which is connected to CAM PCB J20
and controlled by MCM module 7.
Check the adjustments and
the movement area.
E285 Timeout in collimator Y2 lower motor
which is connected to CAM PCB J25
and controlled by MCM module 7.
Check the adjustments and
the movement area.
E286 Timeout in tube head rotation motor
which is connected to CAM PCB J31
and controlled by MCM module 8.
Check the adjustments and
the movement area.
E287 Timeout in lift motor during patient
support vertical movement.
E290 Rotating tube head
in wrong position
Rotating tube head in wrong position. Check the adjustments and
the movement area.
3 Error messages
40 Planmeca Viso Technical manual