10.7
ELECTRICAL
10
Screen 6 - Miles/Kilometers: toggle, The display in the trip
meter and odometer can be changed to display either kilometers
or miles. The current display mode will be shown as “KM” or
“MP”. To change, hold in the mode button until the letters flash,
then press and release the button once. When the display stops
flashing, the mode has been set.
NOTE: As long as you are in the diagnostic mode,
the wrench icon will remain lit.
NOTE: To leave the diagnostic mode, turn the key
switch off and on.
NOTE: Any movement of the tires will trigger the
speedometer out of the diagnostic mode and into
standard display mode.
EFI Diagnostic Mode
NOTE: The EFI diagnostic mode is intended to
quickly view fault codes stored in the EFI module.
Polaris dealers are equipped with the proper
diagnostic tools to further diagnose the blink code.
To download blink codes (failure codes) from you EFI module:
1. Be sure the ATV key switch is off and with the shifter is in
Park.
2. Turn the key switch ON and OFF 3 times within 5 seconds,
leaving the key switch in the ‘ON’ position on the third turn.
3. The word “Wait” will appear, the EFI module is now
searching for blink codes. If any blink codes are stored they
will display in numerical order on the instrument cluster.
NOTE: The check engine icon will flash during this
mode.
4. The word “End” will display after all of the codes have been
displayed.
MP = Miles
KM = Kilometers
ON
Example of how a failure code will appear.
To Next Page
Loading...
Need help?
General
