FINAL DRIVE
7.12
theboot kit. DO NOT usea substitutegrease and DO
NOT overfill or underfill the CV joint.
9. Slide the new clamp and boot (small end first)
overthesplinedshaft, thenslide (tap)theCVjoint
into the splines of the axle. Install small boot
clamp.
10. Add grease through large end of boot.
11. Position large end of boot on CV joint, purge
excess air by partially compressing axle into CV
bell, lift one edge of boot to let out excess air
Secure with
clamp.
Boot Replacement requires 30g
Boot replacement with complete CV
joint cleaning requires an additional
30g. (Total 60g)
CV Boot Clamp Pliers:
Earless Type (PN 8700226)
CV Joint Grease - 30g (PN 1350046)
FRONT SHAFT
Joint Capacity
30 Grams
Boot Capacity
30 Grams
Front outboard joint capacity: 30g if boot
is replaced only. Another 30g (60g total) if
joint is cleaned.
To Next Page
Loading...
