TRANSMISSION
8.4
7. Removeoutputshaftandgearassemblyalongwith
sprocketandchain,bytappingonshaftwithasoft
faced hammer, from the back side of the gear
case.
8. Remove roller chain. Note position of sprockets
andgear. Stretchchain tight on aflatsurfaceand
measure the length of 8 pitches in a minimum of
three places on chain. Replace chain if
measurementislongerthan5.05I (128.27mm).
Measure
8 pitches
Chain Stretch Limit
8 pitch length =
5.05I (128.27 mm) Maximum
9. Use a 1/2″ wrench to rotate bell crank and remove
shift fork, upper shaft assembly, reverse chain
and shaft.
10. Inspect shift fork surface for wear or damage.
Replace if necessay.
11. Remove reverse shaft bearing.
To Next Page
Loading...
