Name: Poly Studio X50
Brand: Poly
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Factory Restore a Ceiling Microphone

You can restore a microphone to its default settings. This process refreshes the device by deleting its

configurations except the current version of software.

Factory restoring the ceiling microphone requires the following tools:

● A small, thin block N45 magnet (for example, 76.2 mm [3 in.] × 12.7 mm [1/2 in.] × 3.18 mm [1/8

in.])

● Yardstick or adjustable floor-to-ceiling pole (so you don’t have to use a ladder)

● Duct tape

1. Tape the magnet to one end of the pole with one of the 3.18 mm (1/8 in.) edges facing up.

CAUTION: If you have a suspended ceiling, tape the magnet securely to avoid it coming loose

and sticking to a ceiling support grid.

2. Ensure that the microphone is powered on.

3. Locate the factory reset sensor.

Looking at the bottom edge of the microphone connector along a longer side of the electronics

enclosure, the sensor is approximately 63.5 mm (2.5 in.) towards the end opposite to the

enclosure’s RJ-45 connector.

If you can’t see the RJ-45 connector, look for the small black button on the microphone cable.

Facing that button at the 12 o’clock position, the sensor is located toward the 9 o’clock position.

116

Chapter 14System Maintenance

Other manuals for Poly Studio X50

Questions and Answers:

Need help?

Do you have a question about the Poly Studio X50 and is the answer not in the manual?

General