Setting Description
Folder Name Specifies the folder name for log transfers. Select one of
the following:
● System Name and Timestamp: Folder name is the
system name and the timestamp of the log transfer.
For example, if the system name is Marketing, the
folder name might be marketing_<date_and_tim
e>.
● Timestamp: Folder name is the timestamp of the log
transfer (for example, <yyyyMMddhhmmssSSS>).
● Custom: Lets you specify a folder name for manual
log transfers.
Storage Type Specifies the type of storage device used for log file
transfers.
Transfer Frequency Specifies when the system transfers logs:
● Manual: The transfer starts when you select the Start
button, which is visible only in the local interface. If
the log fills before you transfer, new events overwrite
the oldest events.
● Auto at Threshold: The transfer starts automatically
when the system reaches the Percent Filled
Threshold.
3. Select Save.
Configure Log Level
You can determine how much detail you want in your G7500 and Studio X series system logs.
1. In the system web interface, go to Diagnostics > Logs > System Log Settings.
2. Configure the following settings:
Table 15-2
Log Level Settings
Setting Description
Log Level Sets the minimum log level of messages stored in the
system’s flash memory. Poly recommends that you use
the default value.
When you enable remote logging, the log level is the
same for both remote and local logging.
Set one of the following log levels. Poly recommends that
you enable automatic transfer of logs to a USB flash drive
when using one of these setting.
● Debug: Logs all messages.
● Info
● Warning
● Critical: Logs the fewest number of messages
Enable H.323 Trace Logs additional H.323 connectivity information. Poly
recommends that you enable automatic transfer of logs
to a USB flash drive when using this setting.
124 Chapter 15Diagnostic Functions
To Next Page
Loading...
Need help?
General
