Name: Poly Studio X50
Brand: Poly
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Configuring Network Settings6

Network settings include the G7500 and Studio X series system primary (wired LAN) and secondary

(Wi-Fi) network configurations. You also can register your system with SIP and H.323 for calling.

Configuring Wired LAN Settings

You can set the wired LAN properties for your G7500 and Studio X series system.

Automatically Obtain IPv4 Address Settings

Your system by default gets its IP address information automatically. If this behavior is turned off, you

can turn it back on.

You must have a DHCP server deployed in your environment.

1. In the system web interface, go to Network > LAN Network > IP Addresses.

2. For IP Address, select Obtain IP address automatically.

Some of your IP address settings populate automatically and are read-only.

3. Select Save.

Manually Configure IPv4 Address Settings

You can manually specify the system’s IPv4 address settings.

1. In the system web interface, go to Network > LAN Network > IP Addresses.

2. For IP Address, select Enter IP address manually.

3. Configure the following settings:

Setting

Description

Your IP Address is Specifies the system IP address.

Subnet Mask Specifies the subnet mask assigned to your system.

Default Gateway Specifies the default gateway assigned to your system.

4. Select Save.

Automatically Obtain IPv6 Address Settings

You can enable your system to use IPv6 addresses and get IP address information automatically.

Configuring Network Settings

Other manuals for Poly Studio X50

Questions and Answers:

Need help?

Do you have a question about the Poly Studio X50 and is the answer not in the manual?

General