● Provides secure connections between the SNMP manager and agent
● Supports IPv4 networks
● Logs all configuration change events
● Supports a user-based security model
● Supports trap destination addresses
Configure SNMP
You can monitor your G7500 and Studio X series system remotely with SNMP.
1. In the system web interface, go to Servers > SNMP.
2. Configure the following settings:
Setting Description
Enable SNMP Enables administrators to monitor the system remotely
using SNMP.
Enable Notifications Enables MIB notifications.
Version1 Enables your system to use the SNMPv1 protocol.
Due to security issues, Poly recommends that you don’t
enable this setting.
Version2c
Enables your system to use the SNMPv2c protocol.
Due to security issues, Poly recommends that you don’t
enable this setting.
Version3
Enables your system to use the SNMPv3 protocol.
Enabled by default, you can’t configure other SNMPv3
settings unless this is on.
Read-Only Community
Specifies the SNMP community string for your system.
For security reasons, don’t use the default community
string (public).
NOTE: Poly doesn’t support SNMP write operations for
configuring or provisioning systems. The community string
is for read operations and outgoing SNMP traps.
Contact Name
Specifies the name of the person responsible for remotely
managing the system.
Location Name Specifies the system location.
System Description Provides details about the system.
User Name Specifies the User Security Model (USM) account name
for SNMPv3 message transactions. The maximum length
is 64 characters.
Authentication Algorithm
Specifies the type of SNMPv3 authentication algorithm
used.
● SHA
● MD5
Configure SNMP 129
To Next Page
Loading...
Need help?
General
