Polycom SoundStation IP 6000 User Manual

User Guide for the Polycom SoundStation IP 6000 Phone
3 - 8
To set up a conference call with an active call and a call on hold:
>> If you have an active call and a call on hold, scroll to either call, and then
press the Join soft key.
The Active:Conference screen displays.
A conference is created with the active call, the call on hold, and yourself.
Holding and Resuming Conferences
When you place a conference call on hold, you place all other conference
participants on hold.
To place a conference call on hold:
>> From the Active:Conference screen, press the Hold soft key.
The Hold:Conference screen displays. The other parties in the conference call
are held.
From the Hold:Conference screen, you can do the following:
• To resume the conference call, press the Resume soft key. The
Active:Conference screen will display again.
• To place a call to a new party, press the New Call soft key. The conference
remains on hold, and the new call becomes the active call.
• To end the conference call and split the conference into two separate calls
on hold, press the Split soft key.

Polycom SoundStation IP 6000 Specifications

General

Network Interface	10/100 Ethernet
Power over Ethernet (PoE)	Yes, IEEE 802.3af
SIP Protocol Support	Yes
Connectivity Technology	Wired
Echo Cancellation	Yes
Noise Reduction	Yes
Speakerphone	Full-duplex
Microphones	3 cardioid microphones
Microphone Type	Cardioid
Display	Backlit LCD display
Audio Technology	HD Voice, Acoustic Clarity Technology
Protocols	SIP
Network Ports	1
Power Source	PoE or optional AC adapter
Weight	1.75 lbs
Compliance	FCC
Dimensions	14.5 x 12.25 x 2.5 in (36.8 x 31.1 x 6.4 cm)