Edition: A03 September 6, 2018
19
3) Counter source
【Edit】
Initial Value: begin value of the counter, range from -999999999999～+999999999999
Maximum Value: Maximum value, range from -999999999999～+999999999999
Repeat Value: The print times of each value, range 0～9999(0 mean not repeat print).
Step Value: Set counter step number .(example: step value is 3, counter will be 1, 4, 7, 11…)
Carry System: Default is DEC, user can select different carry systems, if need to add a new
one, click【Edit】
System List: Show the default and newly built system. It can display a maximum of 5
(including the default base)
New: Click the “new” popup for the system editing interface. Enter the system name and
content, click Save to save the system to the list.
Edit: Select the system, click “edit” to popup the editing interface. Click “save” to save
the changes. The default system cannot be edited.
Select All: All systems in the list will be selected; Click the switch again to change back
to unselect all.
Delete: Select the new systems settings to be deleted. The default system cannot be
deleted
Closing system management: Select close to exit out of management interface and save
existing system.
【Other】
Carry Source: Click the pull-down menu to check the added counter.
Set the counter which the carry is based on (e.g there are counter 1 and counter 2, set the carry
source of counter 2 to be counter 1, then only after counter 1 reached to the maximum value, counter
2 will carry over.)
To Next Page
Loading...
