POLYtij S3i - Page 22

Edition: A03 September 6, 2018
22
Shape
Edit
Others
Straight line
Length：1-3000mm
Line Width：0.1-
2mm
Rectangle,
Width：1-3000mm
Height: single canvas
1-12.7mm,double
canvases 1-25.4mm
Chamfering：0-1/2h
Fill / Stroke：Click to switch to fill the image
Line Width：0.1-2mm，only show graphic
borders. Set to Fill, when image stroke is set,
fill setting is not available.
Circle
Diameter: single
Fill/Stroke：Click to switch if filling the
image
canvas
1-12.7mm,double
canvases 1-25.4mm
Line Width：0.1-2mm，only show graphic
borders. Set to Fill, when image stroke is set,
fill setting is not available.
Ellipse
Short axis: single
canvas
1-12.7mm, double
canvases 1-25.4mm
Long axis：
1-3000mm
Fill/Stroke：Click to switch if filling the
image
Line Width：0.1-2mm，only show graphic
borders. Set to Fill, when image stroke is set,
fill setting is not available.
Name: You must enter at least 1 character, however no more than 30 characters can be entered. You
cannot input symbols (" \ / : *? "< > |").
 7) Newline source
Click newline, it will add in built source list directly, each message can only add one newline,
it can be used several times.
 8) Device Name Source
Generate the device name source directly, the default device information is INKJET. In the 【
System Management】 >【Set up Management】modify equipment information. After saving the
source content it will update automatically. In each message you can build only one device source.
 9) Dynamic Text 【Edit】
Preview: Default text is DYNAMIC TEXT, click to input or modify the preview content.
Name: You must enter at least 1 character, however no more than 30 characters can be entered. You
cannot input symbols (" \ / : *? "< > |").
【Other】
Interface：Default is Ethernet/Standard Protocol.
 10) Logopack source