955725_4
11
Cab Control Module [CCM]
The CCM is installed below the display. If two displays are being utilized only one CCM should
be installed (it does not matter which display it is connected to). All planter control products
being run through the 20|20 require a CCM to be installed as it has a Master Plant switch and
swath control features.
The CCM configuration must be set to Present on the 20|20 display on the User Preference screen
(Setup>Settings>User Preferences).
The switch on the left hand side is the Master Plant switch. For all control products to function
the Master Plant switch must be in the up position. If it is in the down position, all control
products will immediately be disabled.
The three switches in the middle are swath section switches. Toggle these to the down position to
swath off a rate section. If all rows are assigned to the same rate section the planter will be
divided into the three parts with each toggle switch controlling swath for one third of the planter.
If these switches are in the down position, the rows assigned to the switch will be shut off.
Assign rows to rate sections in the vDrive/vSet Select setup screens.
The outside two switches in the middle are also used to auto load the meters. Raise these two
switches up together for one second to load the meters. Meters will spin and dispense some seed
as seed is loaded to the disk. This allows seed to immediately be dispensed from the meter when
beginning to plant.
To continue to spin the meters, lift and hold these two switches. Meters will continue to spin as
long as they are held up.
The switch on the right side is the Master Swath switch. If this switch is in the down position, all
rows will immediately be swathed off.
To Next Page
