955725_4
27
When navigating through the 20|20 there will be a “bread crumb” trail at the top left hand side of
the screen showing the navigation path that has been taken. Select any part of the bread-crumb to
navigate directly to that screen.
Example of a bread crumb trail:
Fields
Precision Planting uses a three tiered naming structure for field names: Client, Farm, & Field.
Each tier of the naming architecture becomes more specific. At all times there will be an active
field. The active field (a field consists of a Client, Farm, and Field name) is the field in which all
data and map is being created for and stored under.
The Fields Menu is where the Client – Farm – Field structure can be created and edited. Select
the Fields Menu from the Navigation Pane after pressing Setup on the home screen. (Selecting
the active field name on the setup page will direct to the same page).
When the Fields menu is selected, the Active
Field name will be displayed with a green
heading. Also, the Client and Farm name of the
Active field will be shown. At the bottom of the
screen other fields for the same Client and Farm
name will be shown. To access the Field Setup
screen for the active field, press on the field
name. To access the field setup screen for a
different field or to make a different field active,
select the field name from the bottom of the
screen. If too many field names exist to fit on the
page, either scroll down by using a single finger
or use the “Search All Fields” function.
Additional field names can be added under the
same Client and Farm name by selecting “Add
Field to current Farm name”.
Use the keyboard on the screen to type in a new
Field name. When finished, press the check mark
on the bottom right side of the keyboard.
To Next Page
Loading...
