955725_4
64
Calibration
Calibration on the Setup Menu will allow the user
to perform tests and calibrations based on the
products and systems installed. Tests and
calibrations available may include GPS Offset
Check, Lift Switch Calibration, Radar
Calibration, see below for further descriptions of
these tests.
GYRO CALIBRATION
Determines the correct Zero Offset percentage setting to meet the desired range.
Tractor must be STOPPED to perform test.
RESET FORCE DIAGNOSTICS
Manually reset event codes for Down Force systems; do not use unless directed to by Product
Support.
ZERO LOAD SENSORS
Determines the correct zero offset for the Force Application's Load Sensors.
Implement must be RAISED to perform test.
GRANULAR MANUAL TEST
Manually test granular application- manually adjust rate and speed while monitoring system
performance
Tractor must be running and systems functional to perform test
To Next Page
Loading...
