side) just enough to allow movement. Do not remove the fastener nuts.
3. Use a 1/2" socket to loosen the first stage belt tensioner and walk the first stage drive
belt off the Input Drive and smaller Step-up Pulley assembly pulleys. Remove the first
stage drive belt.
Installation Instructions
1. Install the first stage drive belt by walking the belt onto the Input Drive and the smaller
first stage Step-up Pulley assembly pulleys. Adjust the First Stage Tensioner enough to
hold the tensioner mechanism and belt in place. Rotate the crank and make sure that
the belt is properly aligned and seated in the pulley grooves.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 107
6 Replacement Procedures
Drive Belt Replacement
To Next Page
Loading...
Need help?
General
