2. Tension the first stage drive belt to either the new or used belt specification, see "First
Stage Drive Belt Tension Adjustment" on page52.
3. Use a 1/2" socket to fully tighten the two Drive Components assembly bolts. Torque
1
bolts to 180 in-lbs +/- 54 (20.3 +/_ 4.5 Nm).
4. Verify that the second stage drive belt is within the new or used belt specified tension,
see "Second Stage Drive Belt Tension Adjustment" on page56. Retention the belt if not
within specification.
1
Torque is a measure of the force that can cause an object to rotate about an axis. Bolt/nut
example: 5 NM torque is equivalent to 5 newton's of force applied one meter from the center of
the bolt, 6 ft-lb is equivalent to 6 lbs of force applied 1 foot away from the center of the bolt.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 108
6 Replacement Procedures
Drive Belt Replacement
To Next Page
Loading...
