Precor Experience Series User Manual

l P10, P30, P30i and P31: (Service menu (51765761) > MACHINE TEST >
CROSSRAMP TEST.
l P62, P80, and P82: (Service menu (51765761) > System Settings > System
Tests > CrossRamp Test.
10. Verify the lift motor calibration distance has not changed:
a. Access the diagnostic CROSSRAMP TEST and set the incline level to 10.
b. Measure and verify the Lift Motor calibration distance remains 9" +/- 1/4" (23 cm
+/- 0.6 cm.
11. Select QUICKSTART and start a manual workout. Operate the machine at the fol-
lowing conditions to verify the Stairarm and ramp incline operation. Make sure that the
Stairarms and ramp movement is smooth and that there are no unusual noises:
l . Raise and lower the INCLINE from minimum to maximum range while varying
the Stairarm speed from 50 to > 150 SPM.
l Repeat this test for several incline cycles.
12. Reinstall the Ramp cover, the Lift Interface Plate cover, and the Front Lift cover, see
"Lift Front Cover Replacement" on page72, "Lift Interface Plate Cover Replacement"
on page76, and "Covers and Panels Replacement" on page69.
13. Verify machine operation and return to service, see "Operation Verification" on page16.
Note:This procedure may have generated lift motor related error codes. Check the
error log and resolve any active error codes, clear the error log on P10, P30, P30i and
P31 consoles.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 168
6 Replacement Procedures
Lift Motor Replacement

Precor Experience Series Specifications

General

Brand	Precor
Model	Experience Series
Category	Fitness Equipment
Language	English