CAUTION:Do not reuse the Ramp Pivot Nylock patch bolt fasteners for installation.
Discard the used bolts and order new bolts for installation (see Exploded View Dia-
grams, bubble # 361).
1. Remove the two #2 Philips pan head screws and remove the Forward Ramp cover.
2. Remove the ramp from the lift motor yoke arm by removing the two 1/2" bolts (2x), wash-
ers (2x), and nuts (2x). Make sure to hold the ramp while removing the fasteners. Retain
part(s) and/or fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 190
6 Replacement Procedures
Ramp Assembly Replacement
To Next Page
Loading...
